|
It's important and easy to check your home for radon. A quick (and free) test is the best way to know if you're home has high levels nearby. And, this article by Malinda Moseley shows you how simple the whole thing can be.
My experience with home radon testing was easy and almost effortless. Here's how I did it:
Step 1:
I read the 5 Minutes of Caring for January 10, 2008.
Step 2:
In doing some research on how to purchase a home radon test kit, I came across the Tennessee Office of Environmental Assistance's Radon Program. I called the toll free number and left my name, address, and phone number on the voicemail. The recording said that I should receive my free radon test within three weeks.
Note: The first three times I called, the voicemail was full. A good indication that this was a popular thing.
Step 3:
I finally received my free home radon test kit in the mail. It took a bit longer than 3 weeks (more like 7 weeks). In fact, to be honest, I had completely forgotten about it. The test kit was free so I can't complain. I also got a packet of helpful information on radon with the test kit.
Step 4:
The test had very specific instructions, which is a good thing as it helps with accuracy. However, I wasn't expecting it. For example:
Test kit must be placed in the lowest area of the house that is used.
All windows and exterior doors must be closed for at least 12 hours before conducting the test.
Test should not be started when severe weather is predicted. (This postponed me doing the test, actually).
Must be placed 2 to 6 feet from floor.
Must be at least 3 feet from windows, doors, or vents.
Must not be near a heat source.
Must not be in a kitchen or bathroom.
All of these stipulations are needed, I understand. However, that left me with few options on where to put it.
Step 5:
In further reading the very specific instructions, I saw that you can actually go online to see the animated test kit instructions. I decided to give it a look. By the way, there are also pictures on the actual kit that show you how to do the test.
Step 6:
After 12 hours of doors and windows being closed, I opened the test. I filled out the required information on the test: start time, temperature in the room, etc. Then I stuck the foam filter in the provided envelope and hung it up. In my case, it added lovely charm to the dining room light fixture.
Step 7:
After three days, I took the test down, removed the foam filter, and sealed the envelope. I finished filling out the required information and put it in the mail.
Step 8:
Two weeks later, I went online and typed in my test number (the number that was located on my test kit) and got my results. It was very easy. We passed!
Step 9:
A few weeks after that, I received my test results in the mail. My Radon Test Result was = <0.3 pCi/L.
Note: "The USEPA states that test results in this range are for all practical purposes equivalent to the radon levels found in fresh air."
I highly recommend doing a home test for radon! It was easy to do!
|
3 others have done this "5 minutes of caring"
To date, you've cared for 0 minutes on CoolPeopleCare.org |
You must be a registered user to post comments.
Log in or create an account.
|
